Mathematical model of heat-hydrodynamic state of the multichamber furnace during the baking of electrode blanks

Authors

  • Антон Янович Карвацький National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056, Ukraine
  • Ігор Валерійович Пулінець National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056, Ukraine
  • Ігор Леонідович Шилович National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2012.3316

Keywords:

Multichamber furnace, gas release, schedule of baking

Abstract

The physical and mathematical models of heat-hydrodynamic state of the chamber of multichamber baking furnace are developed with influence of radiation heat transfer and combustion action of the natural gas

Author Biographies

Антон Янович Карвацький, National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056

Doctor degree of technical sciences, professor

Chemical, polymeric and silicate engineering department

Ігор Валерійович Пулінець, National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056

Graduate student

Chemical, polymeric and silicate engineering department

Ігор Леонідович Шилович, National technical university of Ukraine «Kyiv polytechnic institute» Peremogy Avenue 37, Kyiv, Ukraine, 03056

Candidate degree of technical sciences, associate professor

Chemical, polymeric and silicate engineering department

References

  1. Power saving at production of electrode products [Текст] / Ye.N. Panov, S.V. Kutuzov, A.Ya. Karvatsky [et al.] // XVII Intern. Conf. «Aluminium of Siberia», V Conf. «Metallurgy of Non-Ferrous and Rare Metals», VII Symp. «Gold of Siberia», (Krasnoyarsk, Russia, Sept. 7–9, 2011) : Proceed. of the Intern. Congress, Krasnoyarsk : «Verso», 2011. — P. 412—423.
  2. Малахов С. А. Совершенствование технологи обжига углеграфитовой продукции в многокамерных печах обжига закрытого типа: автореф. дис. на соиск. учен. степени канд. техн. наук : спец. 05.16.02 «Металлургия черных, цветных и редких металлов» / С. А. Малахов. — Владикавказ, 2004. — 30 с.
  3. Шибалов С. Н. Совершенствование тепловых процессов с целью повышения качества обжига заготовок из углеграфитовых материалов: автореф. дис. на соиск. учен. степени канд. техн. наук : спец. 05.16.02 «Металлургия черных, цветных и редких металлов» / С. Н. Шибалов. — М., 2004. — 30 с.
  4. Riedhammer. Carbon baking technology. Closed type baking furnace. [Електронний ресурс ]. — Дата доступу : квіт. 2011 р. — Режим доступу :
  5. http://www.riedhammer.de/System/00/00/95/9566/ed_enUS/Internetversion.pdf.
  6. Poinsot T. Theoretical and numerical combustion [Текст] / Thierry Poinsot, Denis Veynante. — 2nd ed. — Philadelphia : Edwards, 2005. — 522 p.
  7. A New Eddy-Viscosity Model for High Reynolds Number Turbulent Flows - Model Development and Validation [Текст] / T.-H. Shih, W. W. Liou, A. Shabbir, Z. Yang, J. Zhu // Computers Fluids. — 1995. — Vol. 24, No. 3. — P. 227—238.
  8. Henkes R. A. W. M. Natural Convection Flow in a Square Cavity Calculated with Low-Reynolds-Number Turbulence Models [Текст] / R. A. W. M. Henkes, F. F. van der Flugt, C. J. Hoogendoorn // Int. J. Heat Mass Transfer. — 1991. — Vol. 34 — P. 1543—1557.
  9. Magnussen B. F. On mathematical models of turbulent combustion with special emphasis on soot formation and combustion [Текст] / B. F. Magnussen, B. H. Hjertager // In 16th Symp. (Int'l.) on Combustion. The Combustion Institute. — Pittsburgh, 1976 — P. 719—727.
  10. Spalding D. B. Mixing and chemical reaction in steady confined turbulent flames [Текст] / D. B. Spalding // In 13th Symp. (Int'l.) on Combustion. The Combustion Institute. — Pittsburgh, 1971 — P. 649—657.

Downloads

Published

2012-02-01

How to Cite

Карвацький, А. Я., Пулінець, І. В., & Шилович, І. Л. (2012). Mathematical model of heat-hydrodynamic state of the multichamber furnace during the baking of electrode blanks. Eastern-European Journal of Enterprise Technologies, 1(4(55), 33–37. https://doi.org/10.15587/1729-4061.2012.3316

Issue

Vol. 1 No. 4(55) (2012): Mathematics and cybernetics - fundamental and applied aspects

Section

Mathematics and Cybernetics - applied aspects

License

Copyright (c) 2014 Антон Янович Карвацький, Ігор Валерійович Пулінець, Ігор Леонідович Шилович

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.